Register
Simulate and develop a DC power supply with a range of voltage output equivalent to -20 V to 20 V. The power supply should also be able to provide up to 1 A of output current. Use matlab or tinkercad.
31.8k views
0 votes
Simulate and develop a DC power supply with a range of voltage output equivalent to -20 V to 20 V. The power supply should also be able to provide up to 1 A of output current. Use matlab or tinkercad. Please also explain how it works

User Blankart
by
7.6k points

1 Answer

2 votes

Step-by-step explanation:

I hope this answer is helpful ):

User Egalitarian
by
8.0k points
← Prev Question Next Question →

Related questions

User PGHE
asked Jun 14, 2024 5.1k views
Design a 4-bit ALU in Tinkercad to perform A−B+1?
PGHE asked Jun 14, 2024
by PGHE
8.2k points
1 answer
4 votes
5.1k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
Link Copied!