Register
Autocad is only accurate to 3 decimal places (T/F)
41.1k views
3 votes
Autocad is only accurate to 3 decimal places (T/F)

User Lfalin
by
7.7k points

1 Answer

1 vote

Answer: False, Autocad is not only accurate to three decimal places. Hope this helps! :)

User Artfulhacker
by
8.1k points
← Prev Question Next Question →

Related questions

User Felixmosh
asked Oct 11, 2024 103k views
One of the below options is wrong about the type of AutoCad drawing units. Which one is it?
Felixmosh asked Oct 11, 2024
by Felixmosh
7.5k points
1 answer
4 votes
103k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!