Register
3. What type of current is commonly used to weld ferrous metals
208k views
3 votes
3. What type of current is commonly used to weld ferrous metals

User AlanF
by
8.0k points

1 Answer

0 votes

Answer: Direct current electrode negative (DCEN) (straight polarity) is used most commonly to weld stainless steel and ferrous metals. AC current, with the addition of high frequency, is most

Step-by-step explanation:

User Zuleyma
by
7.3k points
← Prev Question Next Question →

Related questions

User Vinod Tigadi
asked May 17, 2024 27.1k views
Shielded metal arc welding can be used to weld all ferrous and nonferrous metals T/F
Vinod Tigadi asked May 17, 2024
by Vinod Tigadi
7.9k points
1 answer
1 vote
27.1k views
User Tpojka
asked Sep 11, 2024 88.4k views
How are ferrous metals treated for corrosion (What abrasives are used)?
Tpojka asked Sep 11, 2024
by Tpojka
9.0k points
1 answer
0 votes
88.4k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!