Register
this process is accomplished by rotating dies that hammer a workpiece radially inward to taper it as the piece is fed into the dies. this process is:
189k views
4 votes
this process is accomplished by rotating dies that hammer a workpiece radially inward to taper it as the piece is fed into the dies. this process is:

User Digicrat
by
7.4k points

1 Answer

1 vote

Answer:

swaging

Step-by-step explanation:

User Badzil
by
8.8k points
← Prev Question Next Question →

Related questions

User Ritzk
asked Apr 4, 2024 34.2k views
The air hammer tool must be pressed tightly against the workpiece before the tool is turned on. A) True B) False
Ritzk asked Apr 4, 2024
by Ritzk
7.9k points
1 answer
5 votes
34.2k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!