Register
When installing stacks, cones, how far should the target patch surpass the flange of the accessory
127k views
4 votes
When installing stacks, cones, how far should the target patch surpass the flange of the accessory

User Iasia
by
8.3k points

1 Answer

4 votes

Final answer:

When installing stacks, cones, the target patch should surpass the flange of the accessory by at least half of the flange's diameter.

Step-by-step explanation:

When installing stacks, cones, the target patch should surpass the flange of the accessory by at least half of the flange's diameter. This ensures proper alignment and allows for adequate sealing. For example, if the flange diameter is 10 inches, the target patch should extend at least 5 inches beyond the flange.

User DEfusion
by
8.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.2m questions

11.9m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!