Question

If you see a"P"on the CID of a TASER X26ED;

a) Immediately pull the DPM out
b) Turn on the ECD and spark test it
c) Pull DPM out during boot up sequence
d) Leave it alone until after it has finished the boot up sequence

Answer 1

If you see a "P" on the CID of a TASER X26ED, leave it alone until after it has finished the boot up sequence.

Step-by-step explanation:

If you see a "P" on the CID of a TASER X26ED, you should leave it alone until after it has finished the boot up sequence. This is because the "P" indicates that the device is in the process of booting up. Pulling out the DPM or turning on the ECD and spark testing it during the boot up sequence could interrupt the proper functioning of the device. Wait until the boot up sequence is finished before taking any further action.