Register
Procedural changes made to published approaches shall be more restrictive than existing procedures, necessary for safety, and meet criteria set forth in FAAO 8260.3 or appropriate service TERPS directive.
155k views
4 votes
Procedural changes made to published approaches shall be more restrictive than existing procedures, necessary for safety, and meet criteria set forth in FAAO 8260.3 or appropriate service TERPS directive.

User Kustomrtr
by
8.4k points

1 Answer

1 vote

Final answer:

This question addresses procedural changes in aviation that must be more restrictive and safety-oriented, adhering to FAAO 8260.3 or the service TERPS directive.

Step-by-step explanation:

The question pertains to procedural changes to published approaches regarding aviation and these modifications must adhere to certain criteria for safety reasons.

Specifically, any alterations must be more restrictive than the existing procedures to ensure enhanced safety measures are in place.

.These changes are guided by the Federal Aviation Administration Order (FAAO) 8260.3 or the appropriate service Terminal Instrument Procedures (TERPS) directive.

t is essential that these changes meet or exceed the established benchmarks for safety and efficiency in aviation procedures.

User Onedayitwillmake
by
8.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
A three-point bending test was performed on an aluminum oxide specimen having a circular cross section of radius 3.5 mm (0.14 in.); the specimen fractured at a load of 950 N (215 lbf) when the distance
Homes may be heated by pumping hot water through radiators. What mass of water (in g) will provide the same amount of heat when cooled from 90.7 to 39.4°C, as the heat provided when 182 g of steam is cooled
Link Copied!