Register
The positioning of the machining cutter is controlled by _____. A. G-codes B. F-codes C. M-codes D. S-codes
178k views
2 votes
The positioning of the machining cutter is controlled by _____.

A. G-codes
B. F-codes
C. M-codes
D. S-codes

User Mike Brady
by
8.4k points

1 Answer

0 votes

Final answer:

The positioning of the machining cutter is controlled by G-codes. G-codes are a set of commands used by computer numerical control (CNC) machines.

Step-by-step explanation:

The positioning of the machining cutter is controlled by G-codes. G-codes are a set of commands used by computer numerical control (CNC) machines to control the position, movement, and speed of the machining tool. These codes determine the path and actions that the cutter takes to produce the desired shape or cut.

User Albatross
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.2m questions

11.9m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Teresa is emotionally volatile, particularly with friends and boyfriends. She is extremely dramatic about even the smallest disappointments and is sexually and behaviorally very impulsive. Teresa would
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
Link Copied!