Register
The vertical deviation pointer is displayed as a ______________________. When you are in ILS/LOC mode your glide slope and deviation pointer will be ________________. When in VOR or other mode, the course
234k views
0 votes
The vertical deviation pointer is displayed as a ______________________.

When you are in ILS/LOC mode your glide slope and deviation pointer will be ________________. When in VOR or other mode, the course deviation pointer will be a _______________.

User Ridwan Budiman
by
8.0k points

1 Answer

2 votes

Final answer:

The vertical deviation pointer is displayed as a glideslope indicator. In ILS/LOC mode, the glide slope and deviation pointer will be centered. In VOR or other modes, the course deviation pointer will indicate the horizontal deviation from the desired course.

Step-by-step explanation:

The vertical deviation pointer is displayed as a glideslope indicator.

When you are in ILS/LOC mode, your glide slope and deviation pointer will be centered.

When in VOR or other modes, the course deviation pointer will indicate the horizontal deviation from the desired course.

User Carlyle
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
If a host system is 80% efficient, the minimum horsepower rating of the motor should be ? if the hoist is to provide 20,000 ft-lb/s. a) 45.45hp b) 23,530hp c) 36.36hp d) 42.78hp
Link Copied!