Register
The surface of all equipment, including, but not limited to back-bars must be made of _______. This requirement does not apply to the ________ of a facility where services are not performed.
159k views
1 vote
The surface of all equipment, including, but not limited to back-bars must be made of

_______. This requirement does not apply to the ________ of a
facility where services are not performed.

User Maziar
by
8.7k points

1 Answer

2 votes

Final answer:

The surface of all equipment should be made of nonporous materials, and this requirement does not apply to administrative areas of a facility where services are not performed.

Step-by-step explanation:

The surface of all equipment, including, but not limited to back-bars, must be made of nonporous materials. This requirement does not apply to the administrative areas of a facility where services are not performed.

User Maccurt
by
8.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Link Copied!