Register
All swimming pools, spas, and hot tubs must be enclosed with a fence, building wall, a wall that completely surrounds and obstructs access to the swimming pool. The top of the obstruction, whether a fence
182k views
5 votes
All swimming pools, spas, and hot tubs must be enclosed with a fence, building wall, a wall that completely surrounds and obstructs access to the swimming pool. The top of the obstruction, whether a fence or a wall, must be the minimum of ___ inches above grade.

User JJD
by
8.5k points

1 Answer

4 votes

Final answer:

The minimum height requirement for enclosures around swimming pools, spas, and hot tubs is 48 inches (4 feet) above grade.

Step-by-step explanation:

The subject of this question is Health. The question is asking about the minimum height requirement for enclosures around swimming pools, spas, and hot tubs. The answer can be found in local laws and regulations regarding pool safety.

According to the International Swimming Pool and Spa Code (ISPSC), the top of the obstruction, whether a fence or a wall, must be at least 48 inches (4 feet) above grade. This requirement is in place to prevent unauthorized access to the pool and ensure safety.

Swimming pool enclosures are important to prevent accidents, especially for young children who should never be left unattended around water sources that pose a drowning risk.

User Jeff Mergler
by
7.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!