Register
In CAD drafting, section views are drawn with crosshatching patterns using what command-----------
193k views
3 votes
In CAD drafting, section views are drawn with crosshatching patterns using what command-----------

User Jessann
by
8.1k points

1 Answer

3 votes

Final answer:

Section views in CAD drafting are drawn with crosshatching patterns using the HATCH command.

Step-by-step explanation:

In CAD drafting, section views are drawn with crosshatching patterns using the HATCH command.

User Cedric Cholley
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
In solid motors, HTPB and PBAN are two common types of plasticizers. a) True b) False
Where are all the controls on most circuits?
Link Copied!