Register
Which statement is NOT true about recycling and recovery equipment manufactured after November 15, 1993? a) It must be tested by an EPA-approved third party. b) It must meet vacuum standards more stringent
51.1k views
5 votes
Which statement is NOT true about recycling and recovery equipment manufactured after November 15, 1993?

a) It must be tested by an EPA-approved third party.
b) It must meet vacuum standards more stringent than those met by equipment manufactured before November 15, 1993.
c) It must be equipped with low-loss fittings.
d) It must have an oil separator.

User Altercation
by
7.7k points

1 Answer

2 votes

Final answer:

The statement that is not true about recycling and recovery equipment manufactured after November 15, 1993 is that it must have an oil separator.

Step-by-step explanation:

The statement that is NOT true about recycling and recovery equipment manufactured after November 15, 1993 is: d) It must have an oil separator.

After November 15, 1993, recycling and recovery equipment must meet certain requirements set by the Environmental Protection Agency (EPA). These requirements include:

  1. Being tested by an EPA-approved third party
  2. Meeting more stringent vacuum standards than equipment manufactured before November 15, 1993
  3. Being equipped with low-loss fittings

However, having an oil separator is not a requirement for recycling and recovery equipment manufactured after November 15, 1993.

User Takrishna
by
8.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!