Question

Change switch 0 name to sw1, switch 1 name to sw2, both switches should belong to the domain name kh. In switch 1:

A) Set the name to sw1
B) Set the domain to kh
C) Set the name to sw2
D) Set the domain to kh

Answer 1

To configure switches 0 and 1, you set the names to sw1 and sw2 respectively, and the domain to kh for both switches.

Therefor the correct answer option is A)

Step-by-step explanation:

The question pertains to configuring network switch settings within a particular domain. To change the name of switch 0 to sw1 and switch 1 to sw2, and to set their domain to kh, you would perform the following actions on each switch respectively:

For switch 0 (to become sw1):

Set the name to sw1.

Set the domain to kh

For switch 1 (to become sw2):

Set the name to sw2.

Set the domain to kh

These configurations are usually accomplished through a Command-Line Interface (CLI) on the switch. It's a straightforward process where you access the switch configuration mode and make the necessary changes to its settings.