Final answer:
To reset the fire alarm system after activation from a manual fire alarm pull station, authorized personnel must reset the pulled station, access the fire alarm control panel, press 'Reset' to clear the alarm, and wait to ensure the system returns to normal. It's important to adhere to manufacturer's instructions and fire safety regulations.
Step-by-step explanation:
The correct way to reset the fire alarm system after an alarm is activated from a manual fire alarm pull station involves several steps. Once the area has been confirmed safe and the emergency services have stated it is okay to do so, an authorized person should go to the fire alarm control panel. The following general steps are typically involved, though specific procedures can vary depending on the system:
- Locate and reset the activated manual pull station to its original position.
- Go to the fire alarm control panel and enter the access code if required.
- Press the 'Reset' button on the panel to clear the alarm condition and return the system to a normal state.
- Wait for a few moments to ensure the system resets and no alarms are present.
It is important that only properly trained personnel perform this action, as improper handling of the fire alarm system may lead to system malfunction or non-compliance with fire safety regulations. Keep in mind that these are general steps and one should always follow the manufacturer's instructions or the policies of the local fire department.