Register
Where do you place warning if you stop on a one-way or divided highway? 1) On the left side of the vehicle 2) On the right side of the vehicle 3) In front of the vehicle 4) Behind the vehicle
12.4k views
4 votes
Where do you place warning if you stop on a one-way or divided highway?

1) On the left side of the vehicle
2) On the right side of the vehicle
3) In front of the vehicle
4) Behind the vehicle

User Saulmm
by
8.6k points

1 Answer

3 votes

Final answer:

When stopping on a one-way or divided highway, place the warning device on the right side of the vehicle to effectively alert other drivers approaching from behind.

Step-by-step explanation:

When stopping on a one-way or divided highway, you should place your warning device on the right side of the vehicle. This is typically done by activating the hazard lights or placing caution triangles or flares on the right side of the road behind your vehicle.

Placing the warning device on the left side, in front of the vehicle, or behind the vehicle will not effectively alert other drivers approaching from behind.

User Paparush
by
8.2k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The pressure at any point in a static fluid depends only on the Select one a)- depth, surface pressure, and specific weight. b)- specific weight. c)- surface pressure and depth. d)- depth and container
A face milling operation is to be performed on cast iron. Tool diameter is 5 inches, w = 2 inches, part length = 8 inches, depth of cut = 0.012 inches, f = 0.001 inch/tooth, and N = 250 RPM. Find: MRR,
A three-point bending test was performed on an aluminum oxide specimen having a circular cross section of radius 3.5 mm (0.14 in.); the specimen fractured at a load of 950 N (215 lbf) when the distance
Link Copied!