Register
When looking at the ANSI/ASHRAE Standard 34-201, how can flammability be recognized? 1) letter A 2) letter B 3) numbers 1-3 4) numbers 4-6
207k views
4 votes
When looking at the ANSI/ASHRAE Standard 34-201, how can flammability be recognized?

1) letter A
2) letter B
3) numbers 1-3
4) numbers 4-6

User Arbalest
by
8.6k points

1 Answer

6 votes

Final answer:

Flammability can be recognized by the letter A in the ANSI/ASHRAE Standard 34-201, as well as the level of fire hazard indicated by the red diamond in the NFPA 704 Hazard Identification System. Flash points can also provide information about flammability.

Step-by-step explanation:

Flammability can be recognized in the ANSI/ASHRAE Standard 34-201 by the letter A. In the NFPA 704 Hazard Identification System, the top (red) diamond specifies the level of fire hazard, with 4 indicating an extremely hazardous substance. Additionally, flash points can help determine the flammability of a substance, with a lower flash point indicating higher flammability.

recognized in the ANSI/ASHRAE Standard 34-201 by the letter A. In the NFPA 704 Hazard Identification System, the top (red) diamond specifies the level of fire hazard, with 4 indicating an extremely hazardous substance. Additionally, flash points can help determine the flammability of a substance, with a lower flash point indicating higher flammability.

User Rich Sadowsky
by
9.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!