Register
When performing a routine inspection on personnel parachutes, What happens to the ejector snaps? 1) They break 2) They get stuck 3) They detach 4) They become loose
144k views
5 votes
When performing a routine inspection on personnel parachutes, What happens to the ejector snaps?

1) They break
2) They get stuck
3) They detach
4) They become loose

User Mark Good
by
8.0k points

1 Answer

1 vote

Final answer:

The correct answer is option 3) They detach. During a routine inspection of personnel parachutes, the ejector snaps are detached and inspected for any signs of wear or damage. If any issues are found during the inspection, the ejector snaps are replaced with new ones.

Step-by-step explanation:

When performing a routine inspection on personnel parachutes, the ejector snaps undergo a specific process. The ejector snaps are detached and visually inspected for any signs of wear, damage, or malfunction. This is important to ensure the safety and functionality of the parachute system. If any issues are found during the inspection, the ejector snaps are replaced with new ones. This is necessary to guarantee that the parachute can properly detach and deploy when needed.Therefore, the correct answer is option 3) They detach.

The correct answer is option 3) They detach. During a routine inspection of personnel parachutes, the ejector snaps are detached and inspected for any signs of wear or damage. If any issues are found during the inspection, the ejector snaps are replaced with new ones.

User Daniel Mensing
by
8.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!