Final answer:
Inspecting the CRU-60 mounting bracket involves preparing two 4 cm long pieces of tape with handles, placing them on a non-metallic surface, hanging them to observe for stickiness, and finally bringing them together to ensure they do not stick to each other.
Step-by-step explanation:
The procedure for inspecting the CRU-60 mounting bracket using nylon binding tape is a methodical process. This procedure requires careful attention to ensure the integrity and safety of the harness. When inspecting the bracket, the nylon binding tape must be handled in a specific way.
- Prepare two pieces of tape about 4 cm long. To make a handle, fold about 0.5 cm at one end so that the sticky sides are together, creating a non-sticky handle.
- Place these pieces of tape side by side on a nonmetallic surface. This surface can be something like a tabletop or chair's seat.
- Peel off the tapes and let them hang downward by holding them from the handles you created. If the tape curls and sticks to your hand, adjust the length of your tape or shake it free.
- Bring the two pieces of tape slowly towards each other and observe their behavior. They should not stick together if handled correctly with clean hands and the proper length of tape.