Register
What should a driver do when he/she gets to a speed bump? 1) Slow down and proceed with caution 2) Speed up to go over the bump quickly 3) Ignore the speed bump and continue at the same speed 4) Stop and
232k views
5 votes
What should a driver do when he/she gets to a speed bump?

1) Slow down and proceed with caution
2) Speed up to go over the bump quickly
3) Ignore the speed bump and continue at the same speed
4) Stop and wait for the speed bump to be removed

User Theo Scholiadis
by
8.5k points

2 Answers

7 votes

Answer:

number 1

Step-by-step explanation:

bc that the only one that right bc I just had to answer that on my driver quiz

User Zheyuan Li
by
8.5k points
3 votes

Final answer:

A driver must slow down and proceed cautiously over a speed bump to ensure safety and prevent vehicle damage.

Step-by-step explanation:

When approaching a speed bump, a driver should slow down and proceed with caution. Speed bumps are designed to enforce a lower speed limit and enhance safety, making option 1 the correct action to keep both the vehicle's occupants and pedestrians safe. Ignoring or speeding up over speed bumps can cause harm to the vehicle and jeopardize the safety of all nearby.

User Robinkunde
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!