Register
Can the Launching Station inadvertently slew when the PDU (A1A2) Motor Control Unit AC is set to ON, even if the Launching Station is in Local Control and the key is removed? 1) True 2) False
67.5k views
5 votes
Can the Launching Station inadvertently slew when the PDU (A1A2) Motor Control Unit AC is set to ON, even if the Launching Station is in Local Control and the key is removed?

1) True
2) False

User FJDU
by
8.2k points

1 Answer

3 votes

Final answer:

When the PDU (A1A2) Motor Control Unit AC is set to ON, the Launching Station can inadvertently slew even if it is in Local Control and the key is removed.

Step-by-step explanation:

When the PDU (A1A2) Motor Control Unit AC is set to ON, it means that the power supply for the launching station is turned on. The key being removed from the local control does not affect the operation of the motor control unit or the launching station.

Therefore, even if the Launching Station is in Local Control and the key is removed, the Launching Station can still inadvertently slew when the PDU (A1A2) Motor Control Unit AC is set to ON.

User Skizz
by
8.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!