Register
Since 2007 less than____of driver training instructors we had interviewed about ESC could into what it is, how it works, or best way to drive with it.
19.9k views
2 votes
Since 2007 less than____of driver training instructors we had interviewed about ESC could into what it is, how it works, or best way to drive with it.

User GPMueller
by
7.9k points

1 Answer

2 votes

Final answer:

The question is about the understanding of driver training instructors regarding Electronic Stability Control (ESC) in cars.

Step-by-step explanation:

The subject of this question is Cars. The question is asking about the knowledge and understanding of driver training instructors regarding Electronic Stability Control (ESC). ESC is a technology in cars that helps prevent skidding or loss of control during abrupt maneuvers.

The question highlights that a significant proportion of driver training instructors were unable to explain what ESC is, how it works, or the best way to drive with it since 2007. This suggests that there may be a lack of awareness or training among some instructors regarding this safety feature.

Overall, the question is related to cars and the understanding of driver training instructors about the functioning and importance of Electronic Stability Control.

User MS Berends
by
9.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!