Register
With an autoshift transmission, if the transmission is in the drive position, : A. you will use a button control to shift through all the gears. B. it will shift gears as needed based on speed and load.
166k views
5 votes
With an autoshift transmission, if the transmission is in the drive position, :

A. you will use a button control to shift through all the gears.
B. it will shift gears as needed based on speed and load.
C. only the top gears will automatically change.
D. none of the above.

User Miles Alden
by
8.3k points

1 Answer

5 votes

Final answer:

An autoshift transmission in the drive position will shift gears as needed based on speed and load.

Step-by-step explanation:

With an autoshift transmission, if the transmission is in the drive position, it will shift gears as needed based on speed and load. This means that option B is the correct answer. Autoshift transmissions, also known as automatic transmissions, are designed to shift gears automatically based on the driving conditions, allowing for a smoother and more efficient driving experience.

User Andrew Veriga
by
9.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!