Question

To use the cycle start button from the SOP, which of the following setup modes should the Remote/Local be set at within the System/Config screen?

1) OP panel key
2) Local
3) Remote
4) External I/O

Answer 1

To use the cycle start button according to the SOP, the Remote/Local setting should be on 'Local' to enable direct engagement from the machine's operator panel.

Step-by-step explanation:

To use the cycle start button from the Standard Operating Procedure (SOP), the Remote/Local should be set at Local within the System/Config screen.

This setting typically allows the machine's cycle start button to be engaged directly on the machine's operator panel, thus the setting being Local. If it were set to Remote or External I/O, it would expect start signals to come from a remote control system or external input/output respectively.