Register
Which of the following is used to tie the arch wire into orthodontic brackets? 1) Ligature wire 2) Elastic bands 3) Rubber bands 4) Metal wires
39.5k views
2 votes
Which of the following is used to tie the arch wire into orthodontic brackets?

1) Ligature wire
2) Elastic bands
3) Rubber bands
4) Metal wires

User Dimmerg
by
8.5k points

1 Answer

4 votes

Final answer:

Ligature wire is used to tie the arch wire into orthodontic brackets.

Step-by-step explanation:

The correct answer is Ligature wire. Ligature wires are used to tie the arch wire into orthodontic brackets. These wires are typically made of stainless steel and serve to keep the arch wire in place within the brackets, allowing it to exert the necessary forces to move the teeth.

User Csaxena
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.3m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!