Register
What is the effect of intergranular corrosion on aluminum alloy parts? 1) It weakens the structural integrity of the parts 2) It improves the corrosion resistance of the parts 3) It has no effect on the
45.9k views
5 votes
What is the effect of intergranular corrosion on aluminum alloy parts?

1) It weakens the structural integrity of the parts
2) It improves the corrosion resistance of the parts
3) It has no effect on the properties of the parts
4) It increases the hardness of the parts

User Trexion Kameha
by
8.0k points

1 Answer

7 votes

Final answer:

Intergranular corrosion weakens the structural integrity of aluminum alloy parts.

Step-by-step explanation:

Intergranular corrosion is a type of corrosion that occurs along the grain boundaries of a metal. In the case of aluminum alloy parts, intergranular corrosion can weaken the structural integrity of the parts. It occurs due to the reaction between the metal and the corrosive environment, causing localized corrosion and the formation of pits or cracks at the grain boundaries.

The effect of intergranular corrosion on aluminum alloy parts is:

  1. It weakens the structural integrity of the parts.

User Victor Martinez
by
8.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Link Copied!