Register
A construction load may not be placed on a concrete structure unless a person qualified in structural design has determined that the structure is _________. 1) Temporary 2) Able to pass inspection 3) Accessible
223k views
0 votes
A construction load may not be placed on a concrete structure unless a person qualified in structural design has determined that the structure is _________.

1) Temporary
2) Able to pass inspection
3) Accessible
4) Able to support the load

User Vlz
by
7.7k points

1 Answer

4 votes

Final answer:

A construction load may not be placed on a concrete structure unless a person qualified in structural design determines that the structure is able to support the load.

Step-by-step explanation:

A construction load may not be placed on a concrete structure unless a person qualified in structural design has determined that the structure is Able to support the load.

This means that before any additional weight is placed on the structure, an expert must assess whether the structure has the capability to handle the added load.

For example, if a construction team wants to place heavy machinery on a concrete floor, a structural engineer would need to analyze the floor's load-bearing capacity to ensure it can support the weight without compromising the structure's integrity.

User Skeggse
by
7.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!