Question

If one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?

A. only on serial interfaces
B. on the full-duplex end of the connection
C. on the half-duplex end of the connection
D. on both ends of the connection

Answer 1

Late collisions would be observed only on the half-duplex end of the connection in this scenario.

Step-by-step explanation:

When one end of an Ethernet connection is configured for full duplex and the other end is configured for half duplex, late collisions would be observed only on the half-duplex end of the connection. Late collisions occur when a device transmits data onto the network while another device is already transmitting, causing a collision. In half duplex mode, collision detection is used, but in full duplex mode, each end of the connection can transmit and receive data simultaneously, eliminating the possibility of collisions.