Question

After you replaced the system board on an HP Workstation, your customer asks you to reconfigure the Hardware RAID.

What should you do first?
A. Set the hard drive jumpers on the system board.
B. Update the device drivers in the Device Manager.
C. Enable RAID in the system BIOS.
D. Enable RAID in the Windows Control Panel.

Answer 1

To reconfigure Hardware RAID after a system board replacement on an HP Workstation, first, enable RAID in the system BIOS. This is the foundational step before setting up RAID volumes and updating device drivers for proper recognition by the operating system.

Step-by-step explanation:

When reconfiguring the Hardware RAID on an HP Workstation after replacing the system board, the first step you should take is to Enable RAID in the system BIOS. This is essential because the BIOS acts as an interface between the hardware and the operating system. Enabling RAID functionality at the BIOS level ensures the RAID configuration is recognized and managed correctly during the boot process and by the operating system once it's loaded.

Once RAID is enabled in the BIOS, upon boot-up, you should be able to configure the RAID volumes as required, using either a RAID configuration utility that comes up during system start or within the RAID controller's BIOS utility that is separate from the system BIOS. Following this, ensure all device drivers are updated in the operating system to allow proper interaction with the newly configured RAID array.