Register
For all other fittings, per Section 40(3) of the PESR, an ABSA SCO must be notified in advance of performing a repair or alteration, orWhen repairs to fittings are outside the scope of an Owner-User program.
137k views
1 vote
For all other fittings, per Section 40(3) of the PESR, an ABSA SCO must be notified in advance of performing a repair or alteration, orWhen repairs to fittings are outside the scope of an Owner-User program.

A) TRUE
B) FALSE

User Sebastian Helzer
by
8.4k points

1 Answer

5 votes

Final answer:

The statement is true; an ABSA Safety Codes Officer must be notified in advance of performing certain repairs or alterations as per Section 40(3) of the Pressure Equipment Safety Regulation.

Step-by-step explanation:

The statement that an ABSA Safety Codes Officer (SCO) must be notified in advance of performing a repair or alteration to fittings, or when repairs to fittings are outside the scope of an Owner-User program as per Section 40(3) of the Pressure Equipment Safety Regulation (PESR) is TRUE. The PESR requires that certain conditions be met when dealing with the repair and alteration of pressure equipment, and one such condition is the involvement of an ABSA SCO in the specified circumstances. It is essential that the owner-user of the pressure equipment complies with this regulation to ensure the safe operation and integrity of the equipment.

User Zxcat
by
8.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!