Register
Never replace a fuse with a ____ fuse, always use the right ____! a) Smaller, conductor b) Larger, circuit c) Different, resistor d) Similar, insulator
114k views
5 votes
Never replace a fuse with a ____ fuse, always use the right ____! a) Smaller, conductor

b) Larger, circuit
c) Different, resistor
d) Similar, insulator

User Aneroid
by
7.9k points

1 Answer

3 votes

Final answer:

The correct answer to the question is b) Larger, circuit. A fuse with a low melting point metal strip breaks the circuit when overheated, serving as a crucial safety feature.

Step-by-step explanation:

Never replace a fuse with a larger fuse; always use the right circuit! The correct answer is b) Larger, circuit. A fuse is a safety device containing a metal strip with a low melting point. When a current higher than what the circuit is designed to handle passes through, the fuse heats up and the metal strip melts, breaking the circuit and preventing potential damage to the electrical system or fire hazards. Replacing a fuse with one that has a higher capacity can allow too much current to flow, posing a significant risk to the circuitry and safety.

User Masyaf
by
8.5k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.1m questions

11.8m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!