Register
Railway crossings can be dangerous in rural areas because: a. There tend to be fewer automated warning systems. b. Brush is more prevalent. c. Your vehicle is more likely to be fully loaded in a rural
113k views
3 votes
Railway crossings can be dangerous in rural areas because:

a. There tend to be fewer automated warning systems.
b. Brush is more prevalent.
c. Your vehicle is more likely to be fully loaded in a rural area.
d. a. and b. are correct.

User IAmWillShepherd
by
7.7k points

1 Answer

3 votes

Final answer:

Railway crossings in rural areas are dangerous due to fewer automated warning systems and the prevalence of brush that can obscure visibility, leading to the correct answer d. a. and b. are correct.

Step-by-step explanation:

Railway crossings can be dangerous in rural areas primarily for two reasons: fewer automated warning systems and the prevalence of brush or other visual obstructions. Automated systems, which include gates, lights, and sound alarms, may not be present in all rural areas, leading to less warning for an approaching train. Additionally, natural vegetation like brush can obscure the view of the tracks, making it difficult for drivers to see an oncoming train in time to stop safely. Therefore, the correct answer to the question is d. a. and b. are correct.

User Timmow
by
7.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!