Register
Where should you always aim the nozzleWhen using a fire extinguisher? A. at the flames directly B. At the flames indirectly C. At the top of the flames D. At the base of the flames
71.1k views
3 votes
Where should you always aim the nozzleWhen using a fire extinguisher?

A. at the flames directly
B. At the flames indirectly
C. At the top of the flames
D. At the base of the flames

User AMember
by
7.3k points

1 Answer

0 votes

Final answer:

When using a fire extinguisher, always aim the nozzle at the base of the flames to effectively put out the fire.

Step-by-step explanation:

When using a fire extinguisher, you should always aim the nozzle at the base of the flames. This is because the base of the flames is where the fuel source is located, and by targeting the base, you can effectively extinguish the fire.

Aiming the nozzle at the flames directly or indirectly, or at the top of the flames, may not be as effective in putting out the fire, as it does not address the source of the flames.

Remember, when using a fire extinguisher, it is important to stand at a safe distance and aim the nozzle at the base of the flames, sweeping from side to side to thoroughly extinguish the fire.

User Sjnarv
by
7.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!