Register
When using a fire extinguisher, what does the acronym PASS mean? A. Pull, Aim, Squeeze, Sweep B. Pull, Arm, Squeeze, Sweep C. Push, Arm, Squeeze, Sweep D. None of the above
216k views
0 votes
When using a fire extinguisher, what does the acronym PASS mean?

A. Pull, Aim, Squeeze, Sweep
B. Pull, Arm, Squeeze, Sweep
C. Push, Arm, Squeeze, Sweep
D. None of the above

User Sworup Shakya
by
8.1k points

1 Answer

4 votes

Final answer:

The acronym PASS used when operating a fire extinguisher stands for Pull, Aim, Squeeze, and Sweep, which are the steps to effectively extinguish a fire.

Step-by-step explanation:

When operating a fire extinguisher, the acronym PASS is vital to remember. It stands for Pull, Aim, Squeeze, and Sweep. Here is what each step entails:

  • Pull: Pull the pin to break the tamper seal.
  • Aim: Aim low, pointing the extinguisher nozzle (or its hose) at the base of the fire.
  • Squeeze: Squeeze the handle to release the extinguishing agent.
  • Sweep: Sweep the nozzle from side to side at the base of the fire until it appears to be out.

Correct operation is crucial for effectively putting out a fire. The correct answer to the student's question is A. Pull, Aim, Squeeze, Sweep.

User Zach Gardner
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!