Register
In Alberta, how can you determine if a helmet is approved? a. Check for the Alberta logo b. Verify through online registration c. Look for the DOT certification d. Consult the manufacturer's website
165k views
0 votes
In Alberta, how can you determine if a helmet is approved?

a. Check for the Alberta logo
b. Verify through online registration
c. Look for the DOT certification
d. Consult the manufacturer's website

User James Crosswell
by
8.6k points

1 Answer

5 votes

Final answer:

In Alberta, an approved helmet must have the DOT certification, which indicates it meets important safety standards.

Step-by-step explanation:

To determine if a helmet is approved in Alberta, the best method is to look for the DOT certification. This safety standard, issued by the Department of Transportation, indicates that the helmet has met specific safety requirements. It is not sufficient to check for an Alberta logo, verify through online registration, or consult the manufacturer's website for approval, as these do not guarantee that the helmet meets the necessary safety standards set by DOT.

User James An
by
8.3k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!