Register
Which two codes are the approved plumbing codes for the State of Texas as of 2001? a) IPC and UPC b) NEC and NFC c) IMC and IBC d) ASHRAE and NFPA
72.1k views
4 votes
Which two codes are the approved plumbing codes for the State of Texas as of 2001?

a) IPC and UPC
b) NEC and NFC
c) IMC and IBC
d) ASHRAE and NFPA

User Prakash Dahal
by
7.9k points

1 Answer

0 votes

Final answer:

As of 2001, the State of Texas approved two plumbing codes: the International Plumbing Code (IPC) and the Uniform Plumbing Code (UPC).

Step-by-step explanation:

The question asks which two codes are the approved plumbing codes for the State of Texas as of 2001. The two approved plumbing codes for the State of Texas are the International Plumbing Code (IPC) and the Uniform Plumbing Code (UPC). These codes provide comprehensive regulations for plumbing systems, ensuring they are installed correctly and safely to protect public health and sanitation.

User Jay Khan
by
6.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!