Register
A clutch is being replaced on a vehicle. Technician A says the flywheel should be replaced or resurfaced. Technician B says that the bearings should be cleaned and reinstalled if ok. Who is correct?
8.8k views
25 votes
A clutch is being replaced on a vehicle. Technician A says the flywheel should be replaced or resurfaced. Technician B says that the bearings should be cleaned and reinstalled if ok. Who is correct?

User ForcedFakeLaugh
by
7.6k points

1 Answer

10 votes

Step-by-step explanation:

resurfacing would only cause slipage on the pressure plate resurfacing could cause problems

User Paul Grime
by
8.4k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Adding moisture is the ONLY way to obtain saturated air from unsaturated air. a)-True b) False
Link Copied!