Question

Assume you have created a global filter and now want to execute a command on data on the original table.

Select one:
a.You can execute the new command, which will eliminate the filtered table.
b.You should click on the Remove Filter button and then run the command.
c. You can do any of these listed.
d.You should close the table, reopen it and then run the command.

Answer 1

To execute a command on the original table after applying a global filter, you should click on the Remove Filter button and then run the command to ensure the entire dataset is affected.

Step-by-step explanation:

If you have created a global filter and want to execute a command on data on the original table, the correct approach is to click on the Remove Filter button and then run the command. This action ensures that the command you want to execute applies to all data in the original table, not just the filtered data. Once the filter is removed, all records in the table will be visible again, and any commands you execute will consider the entire dataset. It is not necessary to close and reopen the table, as this is an unnecessary step that could disrupt your workflow. Moreover, executing a new command without removing the filter may or may not eliminate the filtered table, depending on the software you are using and the type of command you are executing.