Register
(Refer to Figure 20, Area 3). What is the recommended communications procedure for a landing at Currituck County Airport? 1) Transmit intentions on 122.9 MHz when 10 miles out and give position reports
166k views
3 votes
(Refer to Figure 20, Area 3). What is the recommended communications procedure for a landing at Currituck County Airport?

1) Transmit intentions on 122.9 MHz when 10 miles out and give position reports in the traffic pattern
2) Contact Elizabeth City FSS for airport advisory service
3) Contact New Bern FSS for area traffic information

User VasileF
by
7.2k points

1 Answer

5 votes

Final answer:

When landing at Currituck County Airport, the recommended procedure is to transmit intentions on 122.9 MHz when 10 miles out and report positions in the traffic pattern.

Step-by-step explanation:

The recommended communications procedure for a landing at Currituck County Airport is to transmit intentions on 122.9 MHz when 10 miles out and give position reports in the traffic pattern. This procedure ensures that other aircraft in the area are aware of your presence and intentions, contributing to the safety of all aircraft operating in the vicinity of the airport. It is essential to always follow the proper communications protocols as per the regulations and common practice within the aviation community.

User Jon Smock
by
7.1k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.6m questions

11.2m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
Where are all the controls on most circuits?
Link Copied!