Register
A Class T fuse will be noted by its A. fast opening of a circuit under overload. B. use of axial leads on the fuse body. C. typical callout letters of TAN or TAB. D. long body length compared to other
124k views
0 votes
A Class T fuse will be noted by its

A. fast opening of a circuit under overload.
B. use of axial leads on the fuse body.
C. typical callout letters of TAN or TAB.
D. long body length compared to other fuse types.

User Pablo Santamaria
by
8.3k points

1 Answer

2 votes

Final answer:

A Class T fuse is known for its fast opening of a circuit under overload. It has a long body compared to other fuse types.

Step-by-step explanation:

A Class T fuse is identified by its fast opening of a circuit under overload. When excessive current flows through the fuse, the metal strip with a low melting point heats up and breaks the electrical connection. This protects the rest of the circuit from damage. Unlike other fuse types, a Class T fuse has a long body length compared to other fuse types.

User Petek
by
7.6k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.1m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!