Question

Technician A says that when machining rotors The depth Of Kutz should be no more than .407 technician be says that one machining rotors is the first cut is made at high-speed adapted not exceed .10 in.

Answer 1

Technician B's recommendation of 0.10 in is more conservative than Technician A's recommendation for machining rotors.

Step-by-step explanation:

When machining rotors, the depth of cuts is an important consideration. Technician A suggests that the depth of cuts should be no more than 0.407, while Technician B recommends that the first cut should not exceed 0.10 in. Both technicians are referring to different units of measurement. Technician A is using a decimal measurement, while Technician B is using inches. To compare the two, we need to convert the decimal measurement to inches.

If we assume that Technician A's recommended depth of cuts (0.407) is in inches, then it is higher than Technician B's recommendation of 0.10 in. Therefore, Technician B's recommendation of 0.10 in is more conservative than Technician A's recommendation.