Register
All of the following programming methods are used to generate CNC machine code except _____. A. manual data input B. paper tape programming C. conversational language programming D. CAM programming
114k views
5 votes
All of the following programming methods are used to generate CNC machine code except _____.

A. manual data input
B. paper tape programming
C. conversational language programming
D. CAM programming

User John Geliberte
by
7.8k points

1 Answer

2 votes

Final answer:

All of the programming methods mentioned except CAM programming are used to generate CNC machine code.CAM programming, on the other hand, is a computer-aided manufacturing method that uses software to generate machine code based on a 3D model of the part to be machined.

Step-by-step explanation:

All of the programming methods mentioned except CAM programming are used to generate CNC machine code. Manual data input involves manually entering the code using a keyboard or other input device.

Paper tape programming involves storing the code on paper tape and then reading it into the machine.

Conversational language programming involves using a simplified programming language to provide instructions to the machine.

CAM programming, on the other hand, is a computer-aided manufacturing method that uses software to generate machine code based on a 3D model of the part to be machined.

User Pookieman
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!