103k views
5 votes
ARDUINO UNO CODES

- Set digital pins 8,9,10 as outputs

- Set output voltage of the pins with the following order: First pin 8 should be high.Then after 100ms pin 8 should be low and pin 9 should be high. Then after 100 ms pin 9 should be low and pin 10 should be high. Then after 100ms pin 10 should be low and the whole cycle should start again.

User Dreamer
by
8.1k points

1 Answer

2 votes

Final answer:

Use pinMode() and digitalWrite() functions to set the digital pins as outputs and control their voltages in a specific order.

Step-by-step explanation:

To set the digital pins 8, 9, and 10 as outputs, you can use the pinMode() function in Arduino Uno code. Here's an example:

pinMode(8, OUTPUT);
pinMode(9, OUTPUT);
pinMode(10, OUTPUT);

To set the output voltage of the pins in the given order (8 high, then 8 low and 9 high, then 9 low and 10 high, then 10 low), you can use the digitalWrite() function in conjunction with the delay() function to create the desired timing. Here's an example:

digitalWrite(8, HIGH);
delay(100);
digitalWrite(8, LOW);
digitalWrite(9, HIGH);
delay(100);
digitalWrite(9, LOW);
digitalWrite(10, HIGH);
delay(100);
digitalWrite(10, LOW);

This code will continuously cycle through the specified sequence of pin voltages.

User Alex Reynolds
by
8.4k points
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.