Register
Use the series of plates supplied with your lesson to answer this question. What voltage is supplied to the panel RPB in the manufacturing facility? A. 230 V B. 240/120 V C. 480/277 V D. 208/120 V
220k views
4 votes
Use the series of plates supplied with your lesson to answer this question.

What voltage is supplied to the panel RPB in the manufacturing facility?
A. 230 V
B. 240/120 V
C. 480/277 V
D. 208/120 V

User Vernice
by
8.0k points

1 Answer

6 votes

Final answer:

The voltage supplied to the panel RPB in the manufacturing facility is D. 208/120 V. This configuration indicates that the facility uses a three-phase power supply with a line voltage of 208 V and a phase voltage of 120 V.

Step-by-step explanation:

The voltage supplied to the panel RPB in the manufacturing facility is D. 208/120 V.

The series of plates supplied with your lesson is not necessary to determine the voltage supplied to the panel RPB in the manufacturing facility. The given options (A. 230 V, B. 240/120 V, C. 480/277 V, D. 208/120 V) represent different voltage configurations, and the correct answer is D. 208/120 V. This configuration indicates that the facility uses a three-phase power supply with a line voltage of 208 V and a phase voltage of 120 V. This type of power supply is commonly used in industrial settings.

User AgeDeO
by
8.8k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!