Register
If you are unsure about holding a piece of wood to be drilled, then you should always use a to secure the place while a.drilling, B.Clamp C.farger drill bit D.Smallor drill bit E.Awl
19.0k views
17 votes
If you are unsure about holding a piece of wood to be drilled, then you should always use a

to secure the place while a.drilling,
B.Clamp
C.farger drill bit
D.Smallor drill bit
E.Awl

User Jan Koester
by
8.4k points

1 Answer

9 votes
C I took construction class
User Residuum
by
8.3k points
← Prev Question Next Question →

Related questions

User Arunvg
asked Jul 5, 2024 173k views
Which of these does NOT make wood chips when it is used? (awl, lathe, jack plane, drill press)
Arunvg asked Jul 5, 2024
by Arunvg
7.5k points
1 answer
2 votes
173k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.5m questions

12.2m answers

Other Questions

4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Where are all the controls on most circuits?
Link Copied!