Register
What is the representation of a graduated charging cylinder with regulated refrigerant? 1) A cylinder used for charging refrigerant in HVAC systems 2) A cylinder used for measuring the amount of refrigerant
119k views
3 votes
What is the representation of a graduated charging cylinder with regulated refrigerant?

1) A cylinder used for charging refrigerant in HVAC systems
2) A cylinder used for measuring the amount of refrigerant in HVAC systems
3) A cylinder used for regulating the flow of refrigerant in HVAC systems
4) A cylinder used for storing refrigerant in HVAC systems

User Rens Jaspers
by
7.6k points

1 Answer

3 votes

Final answer:

A graduated charging cylinder with regulated refrigerant is used for measuring the amount of refrigerant in HVAC systems

Step-by-step explanation:

A graduated charging cylinder with regulated refrigerant is most commonly used for measuring the amount of refrigerant in HVAC systems.

It is a type of graduated cylinder, which is a piece of laboratory equipment used to measure the volume of a liquid. The cylinder is marked with calibrations that allow for precise measurements of the refrigerant.

A graduated charging cylinder with regulated refrigerant is used for measuring the amount of refrigerant in HVAC systems

User Bdombro
by
7.7k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.3m questions

11.0m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
4. Which of the following is the first thing you should do when attempting to park? A. Securing the parking spot by standing in it B. Turning on your hazard lights C. Confirming the space can fit your
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!