Register
What is the PASS method of application for using portable fire extinguishers?
153k views
5 votes
What is the PASS method of application for using portable fire extinguishers?

User Jennykwan
by
8.3k points

1 Answer

5 votes

Final answer:

The PASS method is an acronym that stands for Pull, Aim, Squeeze, and Sweep. It is a simple and effective way to use a fire extinguisher in an emergency situation.

Step-by-step explanation:

The PASS method is an acronym that stands for:

  • Pull the pin: Pulling the pin will allow you to discharge the fire extinguisher.
  • Aim at the base of the fire: You should aim the nozzle at the base of the fire rather than the flames.
  • SSqueeze the handle: Squeezing the handle will release the extinguishing agent.
  • SSweep from side to side: Move the nozzle from side to side as you extinguish the fire to cover the entire area.

The PASS method is a simple and effective way to use a fire extinguisher in an emergency situation. Remember to follow your local fire safety guidelines and to get professional training on fire extinguisher use if available.

User Keego
by
7.9k points
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

8.8m questions

11.4m answers

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
An activated sludge plant is being designed to handle a feed rate of 0.438 m3 /sec. The influent BOD concentration is 150 mg/L and the cell concentration (MLVSS) is 2,200 mg/L. If you wish to operate the
The bulk modulus of a fluid if it undergoes a 1% change in volume when subjected to a pressure change of 10,000 psi is (a) 0.01 psi (b) 0.001 psi (c) 0.00001 psi (d) 0.000001 psi (e) none of these
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!