Register
What is the layer of material directly over the floor joists called?
132k views
4 votes
What is the layer of material directly over the floor joists called?

User Mohammed Nasman
by
8.6k points

1 Answer

7 votes

Final answer:

The layer of material directly over the floor joists is called the subfloor , provides a stable and even for the finished flooring materials to be installed on top.

Step-by-step explanation:

The layer of material directly over the floor joists is called the .

The subfloor is typically made of plywood or oriented strand board (OSB) and provides a stable and even for the finished flooring materials to be installed on top.

User Saranya Krishnan
by
7.8k points
← Prev Question Next Question →

Related questions

User Chrisis
asked Mar 20, 2024 112k views
Proper end bearing is required for rafters and ceilings joists. What is the minimum recommended end bearing?
Chrisis asked Mar 20, 2024
by Chrisis
8.2k points
1 answer
3 votes
112k views
User Arnial
asked Sep 15, 2024 121k views
Name 2 engineered wood products that may replace conventional joists.
Arnial asked Sep 15, 2024
by Arnial
7.4k points
1 answer
1 vote
121k views
Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Other Questions

A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
What claim do ghost hunters make about energy-detecting devices? They can determine how many spirits are in one location. They can produce sounds that may be confused with ghosts. They can sense the presence
A 200 g projectile is fired with a velocity of 900 m/s toward the center of a 15 kg wooden block which rests on a rough surface. If the projectile penetrates and emerges from the back at a velocity of
If a host system is 80% efficient, the minimum horsepower rating of the motor should be ? if the hoist is to provide 20,000 ft-lb/s. a) 45.45hp b) 23,530hp c) 36.36hp d) 42.78hp
A bar of 75 mm diameter is reduced to 73mm by a cutting tool while cutting orthogonally. If the mean length of the cut chip is 73.5 mm, find the cutting ratio. If the rake angle is 15 deg, what is the
Link Copied!