203,078 views
10 votes
10 votes
One signal vin=0.2sin(wt) is applied to a bridge rectifier where Silicon diodes are used. The peak value of output voltage is expected to be

a)can't be estimated due to insufficient data
b)0.0
c)0.2
d)0.4

1 Answer

15 votes
15 votes

Answer:

This problem has been solved!

See the answer

7. The voltage that must be less than the breakdown voltage of the diode in order to prevent damage to the diode is the ________.

peak inverse voltage

maximum diode voltage

reverse surge voltage

maximum peak voltage

8. Assume the input signal to a rectifier circuit has a peak value of Vm = 12 V and is at a frequency of 60 Hz. Assume the output load resistance is R = 2kΩ and the ripple voltage is to be limited to Vr= 0.4 V. Determine the capacitance required to yield this specification for a (a) full-wave rectifier and (b) half-wave rectifier. Show all work.

9.A full-wave rectifier is to be designed to produce a peak output voltage of 12 V, deliver 120 mA to the load, and produce an output with a ripple of not more than 5 percent. An input line voltage of 120 V (rms), 60 Hz is available. Consider a bridge type rectifier. Specify the transformer ratio and the size of the required filter capacitor. Show all work.

Step-by-step explanation:

User Stpoa
by
3.2k points