Register

A valve stem is pressed into a hole in the wheel of a(n) _____ tire. A) Tubeless B) Bias-ply C) Radial D) Run-flat

A valve stem is pressed into a hole in the wheel of a(n) _____ tire. A) Tubeless B) Bias-ply C) Radial D) Run-flat
112k views
1 vote
A valve stem is pressed into a hole in the wheel of a(n) _____ tire. A) Tubeless B) Bias-ply C) Radial D) Run-flat

User Gor
by
7.5k points

1 Answer

6 votes
a) tubeless

hope this helps!!
User Omkar Puttagunta
by
8.0k points
← Prev Question Next Question →

Related questions

Ask a Question
Welcome to QAmmunity.org, where you can ask questions and receive answers from other members of our community.

9.4m questions

12.2m answers

Categories

Other Questions

A piston-cylinder device fitted with stops in the cylinder walls contains 2.1 kg of water initially at 150 kPa and 30 °C. Heat is transferred to the system until the final temperature reaches 250 °C. The
A water towers lowest point is 405 ft and the main line is 6 feet below the ground. The ground elevation is at 276 ft. The main line travels 2.9 miles. The pipe will travel through the following flanged
A car has an initial speed of 10 m/s. It then undergoes a constant acceleration of 0.05 m/s^2 over a distance of 5 km. Determine: a) The car final speed. b) The time needed to travel the 5 km.
Link Copied!